1/6/2024 0 Comments Gripper downloading![]() Some couplings may require an additional adapter plate. If there is no coupling for your robot, you can process a blank coupling or Robotiq can create a custom version for you. Be sure to use the appropriate coupling for your robot model. Use a coupling to attach the Gripper to the robot. Installing the Gripper onto the robot 3.4.2.1. 3-2: Mounting fingertips on holders (and then on the racks) 3.4.2. 3-1: Mounting the fingers on the racksįig. The figures below list the material and tools needed to mount fingers or fingertips/holders onto the racks of the Hand-E Gripper.įig. Installing the fingers/fingertips/holders on the Gripper Table 3-2: Environmental and operating conditions of the Hand-E Gripper. ![]() Optional Robotiq Universal Controller can use the same power supply. Table 3-1: Hand-E power supply requirements. Recommended power supply with internal protection, otherwise fusing is required. The following table shows the specifications with regards to the power supply required to operate the Gripper and the optional Robotiq Controller. Required power supply must match the Robotiq device. This power supply is not included with the Gripper. The Gripper needs to be supplied by a DC voltage source. Emergency stop is not provided, but its use is strongly advised.The following parts are required for setup : Optional tools if installing fingertip/holder kits: HND-FIN-ALU-KIT, HND-TIP-RUB-KIT, HND-TIP-VGR-KIT, HND-TIP-HLD-KIT ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |